Ferric Chloride 415 MG Chemicals
Ready-to-use etchant solution
  • Manufacturer:
    MG Chemicals
  • Model:
    415
  • SKU:
  • Available:
    1 pcs.
19.11 € (Brutto: 15.54 €)
In stock

Ferric Chloride 415 MG Chemicals

MG Chemicals’ Ferric Chloride is a ready to use copper etchant solution for printed circuit board and photoengraving processes.

Applications and Uses

  •     Etching copper, brass, bronze, Damascus steel, stainless steel
  •     PCB fabrication
  •     Jewelry making
  •     Metalsmithing
  •     Decorate art knives and other metalwork
  •     Steel sign acid etching
  •     Etching pattern welds
  •     Etching on stone surfaces
  •     Colorant in pit-firing some pottery
  •     Glass casting

Features & Benefits

  •     Etching copper, brass, bronze, Damascus steel, stainless steel
  •     PCB fabrication
  •     Jewelry making
  •     Metalsmithing
  •     Decorate art knives and other metalwork
  •     Steel sign acid etching
  •     Etching pattern welds
  •     Etching on stone surfaces
  •     Used as a colorant in pit-firing some pottery
  •     Glass casting

Ferric Chloride FAQ

  • How do I  dispose of ferric Ferric Chloride solution?

There are two ways to do this:

  1.         Contact your local hazardous waste disposal company
  2.         The solution must not be put down the drain because of residual copper ions left in it. To make it safe for disposal, you can add sodium carbonate (washing soda) or sodium hydroxide to neutralize it, until the pH value goes up to between 7.0 and 8.0, testing it with indicator paper. Copper will be deposited as a sludge. Allow the sludge to settle, pour off the liquid, further dilute it with water and pour it down the drain. Collect the sludge in plastic bags and dispose of it as required by your local waste authority.

  • The container of Ferric Chloride is not enough to fill my etching tank.  Should I dilute it with water?

Do NOT dilute ferric chloride with water. You need enough ferric chloride to completely cover your board. You may require up to 5 liters with the Economy Etching Kit and up to 7 liters with the Professional Etching Kit.

  • How do I use Ferric Chloride?

For best results, follow the procedure below.

  •         Fully immerse copper board in solution.

  •         Agitate until etching action is complete.

To speed up etching: Warm the ferric chloride solution between 35 to 55 °C [95 to 131 °F].

ATTENTION! Do NOT heat ferric chloride solution above 55 °C [131 °F].